Hi,

Anyone have a good source for said pins?

These are pins that snap over the edge of a substrate (and are
soldered) to form pins at a right angle. They have to be the
right size/shape to be able to fit into a DIP socket (unlike,
say, 0.025" square pins from a header).

Prefer something that would fit a 0.031" (0.787mm) thick board,
but other sizes could be acceptable.

I'm looking for something that can be purchased at a reasonable
cost in relatively small quantities (~ 10,000 pins).

Thanks for any suggestions,

Best regards,

=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
Spehro Pefhany --"it's the network..."            "The Journey is the reward"
speff@interlog.com             Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog  Info for designers:  http://www.speff.com
Contributions invited->The AVR-gcc FAQ is at: http://www.bluecollarlinux.com
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=