Where is Al Williams web site.  http ??


--- "Randy A." <Cnc002@AOL.COM> wrote:
> Mark:
>
> Try buying some laser or inkjet labels ( I use the 3.5 floppy labels), peel
> off the labels and print the PC trace onto the shiny backing paper the labels
> were on with you laser printer.  Then you can iron them onto the copper clad
> board with a common household iron.  Of course make certain that your board
> is very very clean and also put another piece of paper over the top of the
> backing sheet to put your iron on.  Preheat the board with the iron for about
> 30 seconds to 1 minute before you actually iron on the transfer.  Then place
> the trace printout on the board, put the blank paper sheet on the backing and
> place the iron on it.  Keep the iron with moderate pressure on there and move
> it around slowly for about 2 minutes.  You may have to experiment with the
> heat settings on the iron to get the proper results as irons all differ
> somewhat.  I would start with the lowest and go until I had the setting you
> need.
>
> Carefully peel off the label backing material and hopefully you will have
> your resist trace intact and ready for etching.
>
> You might want to check out Al Williams web site as he has the detailed
> instructions for doing PCBs this way.
>
> Regards and hope this helps,
> Randy A.
>


__________________________________________________
Do You Yahoo!?
Send instant messages & get email alerts with Yahoo! Messenger.
http://im.yahoo.com/