jb wrote:
>
> I've seen a project on Circuit Cellar that used a microcontroller connected
> directly to a NE2000 card making it network-enabled, but there were
> insuffecient circuit and firmware details to build one (some of the project
> was proprietary).
>
> Does anyone have the pin/signal details for a standard NE2000-compatible
> card, and perhaps the command set for setup and tx/rx? I can make my way
> through the Linux drivers I find on the net (that's all the info I find
> software-wise), but none of those offer detailed explanations of the
> signals or commands.
>
> JB

have you looked around at the RFC's they would probably have some pretty
decent protocol specs although they are a pain to track down. I once
found the a protocol specification to connect to a toaster.
http://www.cis.ohio-state.edu/hypertext/information/rfc.html

is a good place to start.

                Damon Hopkins