I've got a couple of solid state relays that I would like to put to use but
I've got a problem with them at the moment, I can't turn them off
completlely. I've got 240 volts hooked up to one and I can turn it on using
5 volts DC. The voltage drop across it's terminals is only 2 volts when
turned on and when I turn it off instead of the voltage being 240 volts
across it's terminals it is 120 volts so therefore it's only half switching
off. Does anyone have an idea as to whats wrong?
Thanks in advance
Regards
Stuart

P.S. I'll be using a PIC to drive this