In a message dated 2/8/00 5:09:18 AM Central Standard Time,
jane_ifurung@YAHOO.COM writes:

> If I have a 3.5Vpp signal with the ground (0V) or
>  reference halfway the signal (ac coupled), would the
>  4066 be able to switch it? The 4066's VCC pin is
>  connected to 5V. Or should I use an analog switch that
>  has a + and - supply?
>
>  I've tried using 4066 but sometimes, the negative peak
>  of my signal would clip.
>

  I've used the 4066 as an audio switch for preamp apps. You can either use a
+/-6 volt supply powering the 4066 and other devices that are up/downstream
the 4066, or use 2 100 ohm 1 watt resistors like this:

        +12 V  ---WW----+---WW---- GND
                      |              |
                Vdd     Vss

   Sure this arragement draws lots of current and gets warm, but it works
flawlessly in my own system.