Oscar wrote:
>
> Hello
> Is there any programmer (with software for dos/w95) that you can bulid
> that support pic16f873?

DT001 SimmStick Programmer Kit.
As well as being a full PICmicro development platform, this
programmer has a 4PDT switch which allows you to program a
PIC16F87x in a SimmStick and run the program straight away.
Yes, a load and go operation. This means you don't have to move
the PIC16F873 chip from the programmer to a target board as they
are one and the same. LOAD/RUN. Straight away!!
http://www.dontronics.com/pickaxe.html
http://www.dontronics.com/dt001.html
http://www.dontronics.com/dt106.html

DIY KIT-96 Serial PIC Programmer.
This 8, 18, 28 & 40 pin PICmicro programmer
Kit runs off the Parallel Printer Port of a PC.
http://www.dontronics.com/diyk96.html

P16PRO Software Registration for the above three kits.
(PIC16F84 software is free)
http://www.dontronics.com/p16pro.html

DIY KIT-117 KIT.
PICALL Serial PIC Programmer. This 8, 18, 28 & 40 pin PICmicro
programmer Kit runs off the Parallel Printer Port of a PC,
programs the PIC16C54, PIC16C55, PIC16C56, PIC16C57, and the
PIC16C58, as well as all other PICmicro chips in the PIC16PRO
range. It includes a programmed chip, and no software
registration is required. As well as the vast range of PICmicro
devices, the PICALL hardware kit can also program ATMEL AVR
micros AT90S12000, AT90S2313, AT90S4414 and AT90S8515's.
http://www.dontronics.com/picall.html

Don McKenzie    mailto:don@dontronics.com      http://www.dontronics.com

World's Largest Range of Atmel/AVR and  PICmicro Hardware and  Software.
Free Basic Compiler and Programmer http://www.dontronics.com/runavr.html