> I think so.  I'm using it in MMC mode, but a quick scan of the spec
> does not show any place where it must be cycled high.
>
> Be careful that you send the CMD0 with CORRECT CRC, becuase
> the MMC is in native MMC mode until the CMD0 is sent with CS low.
> After the CMD0, the card switches to SPI mode and the CRCs are
> "don't care" (unless you turn them on).
>
> Hex code for CMD 0 is always: 40 00 00 00 00 95
>
> Octavio, what socket are you using for the MMC?  Who supplies it?
>
> Regards,
>
> Barry.

Hi Barry and others,
I'm still looking for connectors, right now I'm using
a 100 mils edge connector saved fro an old cable, but any
floppy disk cable will do.
You can try to buy a MMC connector from AMP p/n# 97-8415-01-1
Please let me know if you were successful buying it.
Would you mind to share your code to access the MMC?
I also doing a PC reader for it.
Friendly Regards

Octavio Nogueira
===================================================
nogueira@propic2.com                  ICQ# 19841898
ProPic tools - low cost PIC programmer and emulator
http://www.propic2.com
===================================================