At 10:12 AM 12/28/99 +0000, Dave wrote: >Robert A. LaBudde wrote: > > > > > I wrote the following sample ("sqwave.sti"): > > > > !12.28.99 23.15 SQWAVE.STI > > !stimulus file for SQWAVE.ASM > > CYCLE GPIO1 GPIO2 GPIO3 > > 1 1 0 0 > > > >I don't have MPLAB or the documentation to hand so I could be wrong, but I >believe the first line of a stim file MUST always begin with CYCLE... etc. >If you put remarks or anything else there then the whole file is ignored! > >I vaguely remember this catching me out as a Microchip newbe a few months >ago since I always fully document everything fully and it came as a surprise >that you cannot use a header in a stim file. That doesn't seem to change the result. GPIO remains unchanged as I step through the program. ================================================================ Robert A. LaBudde, PhD, PAS, Dpl. ACAFS e-mail: ral@lcfltd.com Least Cost Formulations, Ltd. URL: http://lcfltd.com/ 824 Timberlake Drive Tel: 757-467-0954 Virginia Beach, VA 23464-3239 Fax: 757-467-2947 "Vere scire est per causae scire" ================================================================