Jake Szot wrote:
>
> > Are you taking into account, pin RB.3 and how it affects programming?
>
> We were leaving RB3 alone. We didn't want to do any low voltage
> programing. If you are only concerned with high voltage programing do
> you need to take any precautions with RB3?

Try this then. It is a simple HV programming fix when the config is set
for LV programming. (default)

Put a 10K resistor from RB.3 to VCC and a 100nF from RB.3 to ground.


--
Best regards

Tony

http://www.picnpoke.com
Email sales@picnpoke.com