Mark: Give Tim at a call off list. He helped me out a while back. Kelly >-----Original Message----- >From: pic microcontroller discussion list >[mailto:PICLIST@MITVMA.MIT.EDU]On Behalf Of Mark Willis >Sent: Thursday, November 25, 1999 3:29 AM >To: PICLIST@MITVMA.MIT.EDU >Subject: Anyone with a Home PCB Shop? [OT] > > >Unusual one here; I need some tiny PCB's, sizes like 10mm x 12mm or so, >for little adapters. The first two aren't PIC-related, so I marked this >OT, the third one will be though, if I can get there from here. > >I need about 1mm trace widths, double-sided boards, only 10 traces per >board or so, minimal VIAs & holes. I could do it by hand, but would >rather NOT. Really simple boards, just using PCB's for speed & accuracy >& to avoid having to crimp thousands of connector pins Don't need 4 >mil traces on this one, & want it to be fairly cheap. > >Is anyone on the list able to just plain make these for me, for a >reasonable number? I need some soon, more later, and don't really want >to do all these via hand drawing, if I can avoid that; I can do >drilling & cutting etc., if someone wants to take on this via a couple >sheets of those laser toner resist kits, and etch the board & tin it >(preferably.) I figure one 6"x6" panel or so will last me for a while. > > Mark > >-- >I do small package shipping for small businesses, world-wide. > > William K. Borsum, P.E. -- OEM Dataloggers and Instrumentation Systems & San Diego, California, USA