On Fri, Nov 26, 1999 at 07:31:39AM -0500, Jeff Jolie wrote:
> You will be hard pressed to make PCB's with 1 mil traces in a home PCB shop.
> Usually 8 mil is about all you can reliably do with a direct etch process in

True, but the original poster said 1mm, not 1mil. That's about 39mil. That
should be doable at home.


--
Clyde Smith-Stubbs               |            HI-TECH Software
Email: clyde@htsoft.com          |          Phone            Fax
WWW:   http://www.htsoft.com/    | USA: (408) 490 2885  (408) 490 2885
PGP:   finger clyde@htsoft.com   | AUS: +61 7 3355 8333 +61 7 3355 8334
---------------------------------------------------------------------------
HI-TECH C: compiling the real world.