Ok im using a 24lc32 eeprom conencted to porta.  So far there is no code to rese
t the chip to address 0000, but when reading sequentially from the chip on start
 up ofthe pic everything works fine the FIRST time.  if u reset the pick it no l
onger works...i would assume that this is because the eeprom is still holding th
e previous address accessed and wont forget that address until it is set to a di
fferent one or power is removed??

So, we tried shutting off the power and flickin it back on...This also did not w
ork.  about 10 minutes later..flicked the power back on and the damn thing worke
d as its supposed to.  REmove power, wait 30 seconds apply power again, NOTHING.
.  why is this?  there are no caps on the board saving any charge, its built on
 a bread board..

miKE   (who else...BTW, happy thanksgiving)

Send someone a cool Dynamitemail flashcard greeting!! And get rewarded.
GO AHEAD! http://cards.dynamitemail.com/index.php3?rid=fc-41