Sure, Aaron, I do this all the time.

Most autorouters will always try to make a double sided board.  I finally
stopped fighting and just go ahead and let the autorouter put traces on both
sides.

Then, I attack the autorouted board.  I place all the traces possible on the
solder side, re-route a few of them to make it possible, but then finally I
am stuck with a few traces on the component side that I just can't route.

These are your jumper wires.

-- Lawrence Lile


-----Original Message-----
From: Aaron <azzi_b@AZZNET.FREESERVE.CO.UK>
To: PICLIST@MITVMA.MIT.EDU <PICLIST@MITVMA.MIT.EDU>
Date: Tuesday, November 16, 1999 3:00 PM
Subject: Eagle


Can anyone tell me how to ONLY produce a single sided board in Eagle?

Regards

Aaron