Don,

Send me the file!  Thanks.

I think that you must have either 1) a StampII manual, or 2) a newer version
of the StampI manual.  I bought my Stamps...and the development kit MANY
moons ago.  My manual is 63 pages long(?) and a 1993 Copyright!  Any help
would be MUCH appreciated.

Larry Woods

> -----Original Message-----
> From: pic microcontroller discussion list
> [mailto:PICLIST@MITVMA.MIT.EDU]On Behalf Of Donald Riedinger
> Sent: Sunday, July 25, 1999 5:00 PM
> To: PICLIST@MITVMA.MIT.EDU
> Subject: Re: Looking of simple PIC / dialer circuit
>
>
> The Parallax Basic Stamp Manual (Parallaxinc.com) has a telephone line
> interface on page 361.  DTMF.src was available on the Parallax bbs.  I
> can email it to you.  I believe there was also a DTMF "in" program.
>
> Simple? Of course if you don't mind taking up to 20 seconds to dial a
> number you could use pulse dialing.  All you need is a relay driven by
> the PIC and a loop current resistor.  If this isn't going to be FCC
> approved, you could maybe simplify the telephone line interface just so
> the PIC does something to the line that can be detected as data at the
> other end (PIC driven optocoupler and higher value resistor across
> line).
>
> Don
>
> Larry Woods wrote:
> >
> > I need to be able to dial a phone number, connect to a computer and dump
> > some data.
> >
> > Simple?  If so, where do I find the software/hardware to do it?
> >
> > TIA,
> >
> > Larry Woods
>