Hi to all engineers.


I have a few questions

1. using picmaster 508 probe how can I enable weak pull-up,
    wake up on port change. it doesn't work on picmaster but
    actual pic works ok .

2. in my project I needed to determine logic 0 for cmos below 1,5 volts
   is logic 0 and above 1,5 is logic 1 I didn't    want to use ADC
  and I didn't want to use timer to determine logic 0 so I used
  picmaster probe 508  the voltage I have got was about 1,5 volts
  when I programed the pic it didn't work when I played with pic I found

  that the voltage is different then what I got 3,5 volts after I looked
at
  the data book I  noticed that all inputs are TTL   is this means that
the pic
  is not static sensitive ?

any help will highly appreciated

Andre