Don, I caught the `tail-end' of this but I would recommend doing a
1-1 crimp from the IDC to the DIP header. Adjust the pcb artwork on the
IDC side so that the DIP is correct. When you start `flipping' wires
around (ie: floppy disk cables), you will be sure to raise the cost and
probably bring up reliablity problems.

   - Tom

At 07:13 AM 7/9/99 +1000, Don McKenzie wrote:
>Tim Hamel wrote:
>>
>> Ok Don,
>>
>> I finally got it! You're right in assuming pins 1 & 2 will be reversed.
>> There's a company that solves this:
>>
>> http://www.arieselec.com/products/products.htm
>>
>> Tim H.
>
>I clicked on the page Tim, but didn't chase through it all, I assume
>they do a set of headers to overcome the problem?
>
>Don McKenzie  mailto:don@dontronics.com http://www.dontronics.com
>
>Don's Download Dungeon:   http://www.dontronics.com/download.html
>Australian Electronics Ring http://www.dontronics.com/aering.html
>Win $500USD Cash. Micro design contest:  http://www.simmstick.com