Guys,
    I have successfuly gotten a 16F84 up and running and made an attempt
at getting
a 16F877 up, but I'm stumped.

The pic is programmed correctly (verified using a protoboard, I am
blinking Port D.0 through D.2)

I wired it up using the same "concept" as the 16F84:
    OSCin/OSCout (pins 13/14) to a Crystal (same crystal that I used on
my 16F84, 10mhz).  With 22pf caps to ground.
4.7k resitor to +5v on Pin 1 for MCLR.  +5v on pins 11 and 32 with a
.1uf cap to ground. 12 + 31 to ground.
I then wired pin 21 (Port D.2) to a 470 ohm to a led...

    I don't see any voltage change on port D at all...as if either no
clocks are running, or the chip is in reset... OR I
don't know about something else I should have wired up... Anyone have
any ideas?
        -- Aaron