> Will it be possible to display (scaled) analogue values?

It is using a 16C74 at the moment, but I was thinking of using a 16C65
because it only needs a UART. However, this chip is actually dearer even
without the A2D.

I haven't thought about analog goodies as yet, but it won't be too hard
to add in some analog instructions. The 74 is a little over half full,
so there's plenty or room for extras, and of course, there is the '77.


--
Best regards

Tony

'The Engine' - Design your own programmer.

http://www.picnpoke.com
Email picnpoke@cdi.com.au