-----Original Message----- From: Peter van Hoof To: PICLIST@MITVMA.MIT.EDU Date: Sunday, May 23, 1999 9:25 AM Subject: Re: mplab-step prob? >the easiest way is to open a new watch window , pick gpio from the list #### double click the gpio in the watch window at this point #### i forgot tihis in my post >change the data (press read , modify it , press write) > >Peter > >-----Original Message----- >From: Glen >To: PICLIST@MITVMA.MIT.EDU >Date: Sunday, May 23, 1999 2:22 AM >Subject: mplab-step prob? > > >>hi & thanks for your time, >> >>i'm using mplab to step through a program for a 12c508a.(using step) >>i get to the part of code to test for zero crossing.(code below) >> >>chcycs btfsc gpio,3 ;check for 0 >> goto chcycs >>lw btfss gpio,3 ;check for 1 >> goto lw >> >>when i get to chcycs it just locks into chcycs. >>even when i use step over it still does the same , gets locked ! >> >>how do i get past these 2 loops to keep checking the rest of the >>program. >>i've tried stimulus pins but didn't work ! >> >>i've been reading mike predkos book "programming & customising the pic >>microcontroller" & shows how to use dos sim. >> >>i'm having trouble with the windows simulator. >> >>any good information on how to use windows mplab. >>a decent tutorial would be good. >> >>thankyou for your time >>glen