As in "manual for a Digital Equipment Corp. VT100 glass crt terminal",
as in "display escape codes", or as in "keyboard codes"? If either or both
of the latter two, does it need to be strict VT100 or can it simply be ANSI?
7-bit or 8-bit?

Sorry, I could probably dig up what you need but I'm not sure what
that is.

--Bob

On Tue, May 18, 1999 at 05:09:46PM -0700, Keith Causey wrote:
> Hello All,
>     I am writing an editor for a PIC application and I seem to have
> misplaced my VT100 terminal specifications. Does anyone know where I could
> get a copy of these specifications?
>
> Thanks in advance,
>
> Keith Causey

--
============================================================
Bob Drzyzgula                             It's not a problem
bob@drzyzgula.org                until something bad happens
============================================================