The easy way is to ask your board house to put as many boards per panel as
you want.


At 08:55 PM 5/15/99 -0700, you wrote:
>Traxmaker will allow you to cut and paste.  I usually put multiple small
>boards on one.  Not shareware though, about $300.00.  They have an
>evaluation version on their Web site.  Don't know if the Gerber output
>is disabled or just printing and saving.
>
>There is a shareware router you can get from AP Circuits in Alberta,
>Canada.  I think www.apcircuits.com.  Not sure if it has cut and paste.
>You can also check with their tech support for an answer to your
>question.  They should have an answer.  Pretty good place for cheap high
>quality double sided plated through boards to.
>
>D. F. Welch wrote:
>
>> Sorry for the slightly off topic post.
>>
>> A while back, when it didn't matter to me :),
>> there was a brief discussion on software which
>> would enable the combining of multiple circuit
>> board images on a single panel.  I have a board
>> which is about 1.5" x 1.75", ( Yes it uses a PIC).
>>
>> I would like to make a large panel with a number
>> of boards per panel.  Can anyone point me to
>> software, Preferably freeware or shareware,
>> which will allow copy and paste editing of
>> Gerber files or some other way of accomplishing
>> this task?
>>
>> Thanks in advance for your help.
>>
>> -Dan Welch
>> amersci@flash.net
>
Aidi Moubhij

aidi@mjr.com