In a message dated 3/30/99 1:30:04 PM Central Standard Time, mtdesign@FAST.NET
writes:

> The printed output looks fine no matter what printer I select.
>
>  The Gerber output is missing many of the lines.  I figure that it was
>  probably from using a metric part on a standard grid.  I went and manually
>  changed some line lengths (in non-grid mode) and repositioned them so they
>  would be in the right place clearance- and connection-wise.
>
>  They haven't gotten back to me on this even though they've been informed
>  for over a month.
>
>  Kinda upset, I am!
>
>  Andy
Andy,
I struggled with this for several months.  I remember that, in SuperCAD, the
drawing looked fine but, when you ran the router, it would seem not to see all
of the connections.  Later, I decided to do the layout manually in SuperPCB.
Soon after that, I decided to bite the bullet and have the board layed out
professionally.

I remember, also, that the making of the parts was quite criticle.  You may
want to try re-building the part(s) that are not being picked up in the
Gerbers.
Best regards,
Max