At 12:09 PM 2/27/99 -0800, you wrote:
>On Sat, 27 Feb 1999, Ravi Pailoor wrote:
>
>> Configure the Tx pin of Port C as output.
>
>NO! The UART will not work if the pin is set as output.

GONG!  It does work.  All the programs I have use a 0 in the TRIS bit for
the tx pin.

Andy

   \-----------------/
    \     /---\     /
     \    |   |    /          Andy Kunz
      \   /---\   /           Montana Design
/---------+   +---------\     http://www.montanadesign.com
| /  |----|___|----|  \ |
\/___|      *      |___\/     Go fast, turn right,
                               and keep the wet side down!