At 12:41 AM 2/11/99 -0500, Wagner Lipnharski wrote:
>If the current is high (more than 2mA) when shorting Data 6 to ground, while
>all other LCD pins are low, try to cut and isolate that Data 6 from LCD to
>board and repeat the current
>measurement, now from the board to ground, and then from the LCD to
>ground... then you found it.

That's about where I'm at.. :( I hate to start cutting, but I'm not seeing
a lot of options.
It's all SMD on both sides of the board.

Thanks for the sanity check though, at least I know it ought to work.