Sean,
I am also using MPLAB 3.40 and an MELabs Pocket programmer.
I include the following 3 lines at the top of all my assembler files and
it works fine (no errors and a HEX file is generated).  Make sure
you don't start these lines in column 1 or you will get a warning
message something along the lines of "directive found at
column 1".

 LIST P=16C84, F=INHX8M, R=DEC

 INCLUDE "p16c84.inc"
 __CONFIG _CP_OFF & _XT_OSC & _WDT_OFF & _PWRTE_ON


Hope this helps,
Adam





shb7@CORNELL.EDU on 02/03/99 09:23:52 PM

Please respond to PICLIST@MITVMA.MIT.EDU

To:   PICLIST@MITVMA.MIT.EDU
cc:    (bcc: Adam Bryant/PEAK/MOORE)
Subject:  MPLAB v3.4 question




Hi all,
I am used to using a different assembler but I recently switched to MPLAB.
It works fine except for one thing: if I try to specify the config bits in
my .ASM file, I get the error:
Error[149]   D:\PICASM\FLASH1.ASM 54 : Directive only allowed when
generating an object file
I don't see any option to switch from a .HEX file to an .O file. On a
hunch, I tried adding a /o to the MPASM command line, and the error
stopped, but now it can't find the .HEX file, presumably because it
generated a .O file instead.
How do I get it so I can specify the config fuses and just generate a .HEX
so I can feed it to my programmer software (MELabs EPIC Pocket
Programmer)???
I have been manually specifying the fuses in the programmer software, but I
want to give this code to someone else and I don't want them to have to
bother doing that.
Oh, just one other question, how can I specify in my .ASM file the default
radix and can someone give me the list of radix overrides (I know it has
been posted before, but unfortunately I  deleted it).
Thanks very much,
Sean
|
| Sean Breheny
| Amateur Radio Callsign: KA3YXM
| Electrical Engineering Student
\--------------=----------------
Save lives, please look at http://www.all.org
Personal page: http://www.people.cornell.edu/pages/shb7
mailto:shb7@cornell.edu  Phone(USA): (607) 253-0315 ICQ #: 3329174