>I'm new to pic programming and would welcome some help in a programming a
>pic 16c84 to drive a stepper motor. (with additional output circuit)
>I plan to use portb and need the following output sequence
>
>1001
>1100
>0110
>0011
>
>I need this sequence repeated 350 times to give me a total of 350 x 4 = 1400
>steps. Then the sequence has to be reversed to drive the motor for the same
>number of steps in the opposite direction.
>This circuit is for durability testing of a stepper driven flap.
>I have some ideas for the programming but the urgency of getting it working
>does not allow me to experiment.
>
>Thanks.  Gary  gary.walker2@virgin.net

Gary:
        You might want to have a look at our ELM313 Stepper Motor
Controller chip. Does this sequence for you in an 8 pin package. You'll
still need to provide the clock pulses and power drive, though.

        Jim Nagy
        Elm Electronics
Makers of unique integrated circuits
http://www.elmelectronics.com/