The SSP module does not fully implement Master Mode in hardware.

By the way there are 2 ap-notes on the Microchip site relating to I2C
on midrange PICs.  Go to this URL:


http://www.microchip.com/10/Appnote/Category/16CXX/index.htm

Then have a look at AN554 and AN578.





At 04:33 PM 11/28/98 +0100, you wrote:
>Finally I have found how to send messages in plain text, so here is my
>message again. For those who have read it already, I'm sorry !!
>
>Could anybody send me the software for the I2C routines in assembler for a
>PIC16C63 !! Master Mode!!!!!!!!
>There are two ways to program the I2C possibilities of the PIC : one by
>using the SSP module and another one without using the SSP module. If
>possible could you send me both.
>
>The main questions are :
>
>Can I use the SSP-module of the PIC16C63 to be the single master of a fully
>implemented I2C-bus (this means a bus with many slaves !!) If yes, when I
>move a byte to the register SSPBUF will it be send to the I2C bus without
>writing any software for it ??
>
>When I can't use the SSP module, is there anybody who can give me the source
>code for the I2C routines ?? Or give me some clues !!
>
>Can somebody help me please, its very urgent !!
>
>Greetings from Glenn Goovaerts from Belgium
>
******************************
Richard Katezansky
Tangent Electronics Ltd.
Montreal, Canada
******************************