re: Analog Devices ADXL202

At 02:48 PM 9/18/98 +0200, Pavel Korensky wrote:
[snip]
>For testing and calibration ? I simply clamped the accelerator board to the
>rotary table which is part of my milling machine. The rotary table was
>clamped to the tilt table (also part of the milling machine). The whole
>thing was clamped to my work desk which was adjusted horizontally. I used
>the instrument for measuring if the table is horizontal. I don't know the
>exact english word for this instrument, but it is a plastic package with
>glass tube filled with oil and small bubble.
>
>Nice and repeatable calibration environment.

   Pavel, that's what I need. I had it mounted on a vice on my bench. Not
very stable...

re: Logic Analyzer

>As soon as you will have something finished, please let me know. I already
>prepared a nice case for the logic analyser and I already have nice set of
>HP logic analyser clamps (they are selling them as a spare part for HP MSO
>oscilloscope).

   I was ready to run static tests on a breadboard but my computer failure
has set me back about a month... I've got a lot of engineering files and
application software to move over. I'm hoping that Lattice will allow me to
install the Synario software on the new hard drive. Since I now have a
450Mhz Pentium II with 128M on the newer 100Mhz bus, I'm expecting a
dramatic reduction in the compile/link/fit cycle...

   - Tom