Hi!

I've built a simple RS232 programmer I found somewhere. It's the hardware
that uses just 4 resistors, 2 diodes and one capacitor.

It works fine using the pip-02 software and the com84 driver, but now I
would like to program the PIC using a single command or bat file called from
the C2C compiler IDE.

Questions:

- Does pip-02 have a command line interface? I haven't had any luck
trying -h -?  /h, etc.

- Is there another freely available DOS software compatible with this
hardware wich can program and verify a PIC with a single command?

- Is there any source code (C or TP) available wich I can use to develop
that utility?

Thanks in advance for any reply.

Carlos V. Gutierrez Fragosa - Hermosillo, Mexico
Beeper (62)102818 Clave 3121 Tel(62)156207 Fax(62)146227
carlosg@sca.com.mx  http://www.sca.com.mx
Keyemu project: http://sca.enlace.com.mx/carlosg/keyemu/