Hi...
    i just finish my DT001, i use two 9 volt batteries to run the
programmer and seems to working ok. but once i read the 12c508 blank
chip, it gives me 3FFF on all location.
i did read the feedback from the dontronics site, but i dont understand,
because i dont have a 470pF capacitor from RB7 in my board and the
resistors<r7 & r8> is not in the same lines of RB6, are they talking
about the old board or what? or i need to change teh r10 & r11 to lower
value resistors. will this damage the board.
    also, i am using my MMX 233 computer to run the DT001, will it be
too fast. what type of machine will be suitable ? and i am using the the
ProPic program and it say "writing error in mem0" and the other program
say "verify error", so is there something wrong with program that i
download from internet site.
    any helpful information will be great...
                                                            Tom

______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com