On Fri, Aug 21, 1998 at 01:24:51PM -0600, Matt Bonner wrote: > I don't know the PCM compiler, but your code looks OK (if my comments > above to David are correct). Can you describe your hardware? I have the pic16c715 on a breadboard. +5V is connected to pin 14 and ground is connected to pin 5. Pin 1 on the chip goes to a small round bulb. The other end of the bulb is connected to ground. Pin 2 on the chip goes to the second bulb. The other end of the bulb goes to the ground. I've done simple sanity checks like removing the chip and connecting the +5V that was going to pin 14 directly to both of the wires that would connect to pins 2 and 3 to make sure the circuits complete. -- Joshua M. Free (JMF30) http://www.eboai.org/~josh/ Art washes away from the soul the dust of everyday life - Pablo Picasso