G.Daniel Invent Design wrote:

> Nuno,
>
> If you use a peristaltic pump to feed the carburettor/ injection float
> then the pump revolutions will be very closely related to the fuel
> usage. Normally silicon is used, however if pumping petrol then a rubber
> hose would be required.   OBTW peristaltic pump has tube aranged to be
> held in a part circle around shaft with ballbearings etc rotating to
> squeeze fluid along tube by pressing tube against(part circular)
> housing.

I have first hand experiance with these pumps
These pumps are often used in chemical dosing apps.

HOWEVER as the tubes split on a VERY regular basis I would recomend
the driver wears a fireproof suit at all times !

Peter Cousens
email: peter@cousens.her.forthnet.gr  phone: + 3081 324450, 380534
> snailmail:  Folia, Agia Fotini, Karteros, Heraklion  Crete, Greece.

--
Peter Cousens
email: peter@cousens.her.forthnet.gr  phone: + 3081 324450, 380534
snailmail:  Folia, Agia Fotini, Karteros, Heraklion  Crete, Greece.