Hi all!

I have gone through the programming specs for the 16F8x, and I can't
understand what the 14 bit value does that has to be sent after the `Load
configuration' command. The PC jumps to 0x2000, alright. But then follows
a normal programming cycle, with data load instruction etc. So what is the
data word after the `Load config' command used for? Can I just use it as
the first word to be programmed into the ID/Config area (so that the first
programming cycle does not need a `load data' command)? Or is it just a
dummy value?

Any help would be appreciated.

Bye,
Georg.

=========================================================================
Georg Hager             | Email:   ghager@theorie3.physik.uni-erlangen.de
Theoretische Physik III |                   Tel. (Uni): (+49)9131/85-8815
FAU Erlangen-N"urnberg  |                   Tel. (Pri):   (+49)911/735142
Staudtstr. 7            | Home URL:
D-91058 Erlangen,Germany| http://theorie3.physik.uni-erlangen.de/~ghager/
=========================================================================