Sorry, it is also unclear for me. However, I think a general response
would be of use.

Thanks in advance.

Imre


On Sun, 7 Jun 1998, Ron Stone wrote:

> Hi,
>
> I've been reviewing section 29 (instruction set) of this manual
> (DS31029A)) and have found a couple of examples that I don't understand.
> Perhaps they're errors, but probably not. On pg. 29-29 (MOVF) Example 1:
>
> MOVF  INDF, 0
>
> Before Instruction
>     W=  0x17
>     FSR=0xC2
> Contents of Address (FSR) = 0x00
> After Instruction
>     W = 0x17
>    FSR= 0xC2
> Contents of Address (FSR)= 0x00
>   Z=1
>
> Is this correct?  If so, why?  What would happen if the instruction had
> been: MOVF  INDF, 1 ?
> ----------------------------------------------
>
> On pg. 29-36 (RLF) and similarly for 29-37 (RRF) we have Example 2
>
> RLF  INDF,1
> Before Instruction
>   W= xxxx xxxx
>   FSR= 0xC2
>   Contents of Address (FSR) = 0011 1010
>   C=1
> After Instruction
>   W= 0x17
>   FSR= 0xC2
>   Contents of Address (FSR) = 0111 0101
>   C=0
>
> A few other cases are given where W starts off as unknown and ends up as
> 0x17.
>
> My question is why does W become 0x17?
>
> Thanks for your help and please respond direct.
>
> Ron
> astone@erols.com
>
>