At 03:45 PM 4/27/98 -0400, you wrote:
>Has anybody out there done anything like the following with a single PLD,
>or two PLDs?
>
>Inputs:
>        Clock
>        Data
>        Output_Enable
>        Count
>        Reset
>
>Outputs:
>        16-bit counter output (increments on Count pin state change), and
reset to
>0x0000 or 0xFFFF when pin Reset is put into a certain state.
>        16-bit shift-register output (from Clock/Data transitions)
>        NOTE:  All Outputs are Hi-Z or logic depending on state of
Output_Enable
<snip>

I have not seen anything like this, but I am curious as to its intended
aplication. If I understand you correctly, you basically want a 16 bit
counter with reset which has simultaneous parallel and serial output.
I must just be missing something, the application is probably obvious :)

Sean


+--------------------------------+
| Sean Breheny                   |
| Amateur Radio Callsign: KA3YXM |
| Electrical Engineering Student |
+--------------------------------+
Fight injustice, please look at
http://homepages.enterprise.net/toolan/joanandrews/

Personal page: http://www.people.cornell.edu/pages/shb7
mailto:shb7@cornell.edu
Phone(USA): (607) 253-0315