rcv232.src may be a file that is included in rs232.src and may not be meant
to use by itself.  Hope this helps.
-----Original Message-----
From: Matthew <team_sparky@yahoo.com>
To: PICLIST@MITVMA.MIT.EDU <PICLIST@MITVMA.MIT.EDU>
Date: Friday, April 24, 1998 8:44 PM
Subject: How do I get rcv232.src to run on 16C84?


>I have the "PIC 16CXX Applications Handbook" and I'm trying to run the
>rvc232.src on a 16c84 and I can't get it to do anything.  I'm using
>SPASM to compile it which I also purchased from Parallax.
>
>I've made the code change for a 22k ohm resistor.  I've also marked out:
>
>;reset   begin
>
>Changed the pic16c54 too pic16c84
>
>Compiled with:  SPASM rcv232.src /s
>
>I've used two different programmers:
>
>picstart 16B1 and the ITUtech programmer.  Both seem to program the pic.
>
>Changed the cfg bits to XT, watchdog off
>
>I'm using a 4MHz osc module rather then a crystal, same thing but
>easier, going to OSC1 pin.
>
>I've tried communicating with two different computers running the
>Qbasic program in DOS.
>
>The voltages are correct powering up the chip.  I've tried two
>different pics.  I have 3 pic16f84's but neither of my programmers
>support them.  How convenient, I just spent 80$ on the picstart
>programmer.
>
>The LED's seem to flash once when the circuit powers up but that seems
>to be the end of it.  I've checked the osc with a scope on the osc1
>pin and its good.
>
>Any suggestions?  Please....
>
>Would using a Parallax programmer make things go any easier?
>
>Thanks
>
>_________________________________________________________
>DO YOU YAHOO!?
>Get your free @yahoo.com address at http://mail.yahoo.com
>