Philip Martin wrote:
> 
>  Wonder if any can help with this problem?
> 
> Is there any thing strange about port E on a 16C64, pull ups or anything
> like that.
> 
> Ive got a load of code running in one and on MPLAB the port works fine,
> outputting on each pin as required by the code. But on the board I am
> getting pins going high when they should not, at this exact point in
> the code, on MPLAB they dont?
> 
> Any one got any thoughts. Ive checked the data sheet but that doesn't
> seem to say anything about pull ups or the like.

Make sure your TRISE.4 is not set for PSP mode. I've also stepped in
this one before...

-- 
Friendly Regards

Tjaart van der Walt
mailto:tjaart@wasp.co.za
 _____________________________________________________________
| WASP International http://www.wasp.co.za/~tjaart/index.html |
|       R&D Engineer : GSM peripheral services development    |
|   Vehicle tracking | Telemetry systems | GSM data transfer  |
|    Voice : +27-(0)11-622-8686 | Fax : +27-(0)11-622-8973    |
|              WGS-84 : 26¡10.52'S 28¡06.19'E                 |
|_____________________________________________________________|