A lot of the questions about this would be answered if you go get the
November issue of Electronics Now.  The foil is "pre-etched" for a couple
of minutes to prepare the surface to accept the toner, then cleaned when
finished with xylene and a light brushing with fine steel wool.


Martin R. Green
elimar@bigfoot.com

----------
From:   Tjaart van der Walt[SMTP:tjaart@wasp.co.za]
Sent:   Thursday, October 02, 1997 12:28 AM
To:     PICLIST@mitvma.mit.edu
Subject:        Re: [OT] A new way to make PCB's

>
> (feeling a little uncomfortable about running foil through my HP3)

How can a conductive foil be used in a xerographic process?
(Wet a small section in the middle of a page and try to print on it)

--
Friendly Regards

Tjaart van der Walt
mailto:tjaart@wasp.co.za
 _____________________________________________________________
| WASP International http://www.wasp.co.za/~tjaart/index.html |
|       R&D Engineer : GSM peripheral services development    |
|   Vehicle tracking | Telemetry systems | GSM data transfer  |
|    Voice : +27-(0)11-622-8686 | Fax : +27-(0)11-622-8973    |
|              WGS-84 : 26010.52'S 28006.19'E                 |
|_____________________________________________________________|