Hi there

I am using a 74A for some async TX/RX and would like
to know what the best way of configuring BRGH is?
Either high speed or low speed as I understand that
there is a bug in one of the settings.

I also wrote some code and ran it in the MPLAB
ver 3.22.02. The code is for the 74A is as follows:

ORG     00H
BSF     STATUS,RP0
CLRF    TRISA
CLRF    TRISE
BCF     STATUS,RP0
BSF     PORTA,0
BSF     PORTA,1
BSF     PORTA,4
BSF     PORTE,0
        END

Non of these instructions seem to set the bits,
or that's what the simulator indicates. The only
bit which sets is Port A bit 4. Is it something to
do with their alternate functions?

Thanks in advance

Gavin
vulcan@ihug.co.nz