Hi

When I single step my software in MPLAB on the PICMaster,
the stack window doesn't seem to work with the program, but
rather with some to-be-invented piece of software.

It doesn't show calls, the suddenly it shows an overflow
(after a single embedded assembly step), or underflow,
depending on how it feels at the moment.

Is there anyone with a suggestion or two?

--
Friendly Regards

Tjaart van der Walt
mailto:tjaart@wasp.co.za
 ________________________________________________________
|        WASP International   http://wasp.co.za          |
|   R&D Engineer : GSM peripheral services development   |
|Vehicle tracking | Telemetry systems | GSM data transfer|
|Voice : +27-(0)11-622-8686  |  Fax : +27-(0)11-622-8973 |
|             WGS-84 : 26010.52'S 28006.19'E             |
|________________________________________________________|