>The ability to use EEPROM or Flash parts for early development is a
>fairly strong point, however a major customer will likely use an ICE
>since the cost is only $1-5K and its usefullness is much higher than
>Flash parts, on-chip debugging, and other glitzy technology.

Sometimes (as in RF-related work) ICE's are not usable, and the only way to
verify it in circuit is to have an adequate test plan in place ahead of time.

I sense another thread starting....

Andy

==================================================================
Andy Kunz - Montana Design - 409 S 6th St - Phillipsburg, NJ 08865
          Hardware & Software for Industry & R/C Hobbies
        "Go fast, turn right, and keep the wet side down!"
==================================================================