I must be brain dead. ;) Thanks for the kick start. I knew that back when I
was getting more sleep than 4 hours a night. My FAE missed reminding me of
that one too. Thanks again.



At 10:29 PM 7/31/97 -0400, you wrote:
>Larry,
>
>RA4 is always a Open Collector (Drain) bit.  It can never drive any kind of
>voltage.
>
>If you are driving logic, and have to use this pin, pull it up with a 1K (or
>thereabouts) resistor.
>
>Good Luck,
>
>myke
>>I have the ADCON 1 set to 04 hex and the TRIS A register configured to give
>>bits 4 and 5 as outputs. When I write port a with a BSF instruction I can
>>toggle bit 5 but not bit 4. The Simulator shows it working ok but not the
>>emulator. Anyone have any ideas? I already changed the Bondout chip
>>thinking I had a blown port. As usual these problems happen on deadline and
>>tend to be show stoppers.
>>
>>As always any help or words of wisdom are greatly appreciated.
>>
>>
>>Larry G. Nelson Sr.
>>L.Nelson@ieee.org
>>http://www.ultranet.com/~nr
>>
>>
>
>"If at first you don't succeed, then maybe sky diving isn't the sport for
>you" - Steve Smith
>
>
Larry G. Nelson Sr.
L.Nelson@ieee.org
http://www.ultranet.com/~nr