Andrew Warren wrote: > > Gus Calabrese wrote: > > > From what I can ascertain, the TDE assembler outputs .obj files > > and the PICSTART is looking for .hex files. Is there any way to > > achieve compatibility? > > Uh, yeah, Gus... Just rename the ".obj" files to ".hex". > > I don't know whether the TDE assembler embeds configuration info > in the .obj files. If it does, you may have to clean up the file > by deleting the line or two that contains the configuration... If > those lines exist, they'll probably be at the end of the file; > you'll recognize them by their out-of-range addresses. > > -Andy I did have to delete some configuration data. I discovered that the starting addresses in the .obj file were twice as big as I expected. This was because the addresses in the .obj file referred to byte positions while the assembler assigned addresses on the basis of 14 bit words. Thanks for the help Gus -- ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ WFT Electronics wft@frii.com http://www.frii.com/~wft Gus Calabrese 303 321-1119......voicemail Lola Montes 1799 Uinta Street Denver, CO 80220 EMERGENCY: 791 High Street Estes Park, CO 80517 if no success with wft@frii.com, try .... wft@bigfoot.com