This is not only off topic, but probably a question WAY below the level of
 expertise of the majority of the group.  I haven't found a difinitive answer
 anywhere, so I'm turning here.

My question is about EPROMS.  In a project I'm making I need to interface a set
 of digital lines to a 14 segment display.  The only problem is this... The
 lines are not your normal hex.  They have a funky logic.  I could use a bunch
 of gates and make the output I want, or I could use a PGA.  Neither of which
 are very good solutions for the small size of this application.

I was wondering if I could use an EPROM in this way.  Put the input into the
 address lines and feed the 14 segment display off the output lines.  Would this
 be possible?  I know EPROMS are slower than other ICs, but am I going to be
 able to use this to multiplex displays?

Also, can I drive the display directly from the outputs of the eprom, or do I
 need to use transistors?

Thanks for being patient.
Terry Ewing