DXF does not go well into Word, in fact it did import better when Word was in version 2
than now. Word6 was when the filter stopped working properly.
What happens is that circles in the drawing drop to the bottom of the picture!
I have complained and sent in example documents and files to Microsoft but to no
avail.
So if your DXF does not contain circles - fine, it will import. But otherwise beware of
dropped circles!


Cheers!

Bo Berglund
PaddelvŠgen 10, S-17545 JŠrfŠlla, Sweden
e-mail: bo.berglund@mailbox.swipnet.se



----------
From:   Steve Smith[SMTP:XYGAX@AOL.COM]
Sent:   den 3 juni 1997 00:26
To:     PICLIST@MITVMA.MIT.EDU
Subject:        Re: Programmer Idea

Orcad will DXF out and this goes into MS Word easy
Steve.....