At 09:50 PM 5/30/97 +1000, you wrote:
>Hi there Piclisters,
>l have a question regarding v-ref on RA3 on the 16c73a.
>The data book states 3V min, but can they be run at 2.5v as there
>are not many 3v refs and plenty of 2.5v available.
>If this can be done, can it be done reliably,

I usually use a 2.5V reference and have no problems.  You don't want to go
much _above_ 3V to keep it accurate - don't know why - could be my hardware.

Andy

==================================================================
Andy Kunz - Montana Design - 409 S 6th St - Phillipsburg, NJ 08865
          Hardware & Software for Industry & R/C Hobbies
        "Go fast, turn right, and keep the wet side down!"
==================================================================