> I just finished bringing up some boards I had done by apcircutis and I was
> VERY dissatified with the results.  Over 60% of my vias were not thru
> connected and about 20-30% of my pads as well.  My jumper per inch ratio for
> this board is very high and it was very, very frustating.

I've used APCIRCUITS twice now and have been generally happy with the
results. The first design returned with unplated holes undrilled, and
both designs seem to have had undersized holes for the 35t drill (which
meant that all the headers were either difficult or impossible to
stuff). They delivered the second design one day late, but called me to
let me know about it.

I'll be using them again: With a thoroughly checked design, all holes
plated, and oversized holes/pads for headers, etc.

The convenience of low cost and fast delivery is highly valued!

BTW I havn't been very active on the PICLIST since I changed to DIGEST
mode. To reply I had to edit the entire digest message and insert the
subject manually. Anyone know of an easier way (with Netscape V3.0)?

Regards, Dana Raymond