I'm using a PicStart Plus programmer whit MPLAB v.3.12.00
I tryed to read the calibration parameters of a pic1400/jw (9630 SAT, made
in Thailand) but the result was invalid data. I used this procedure:

        1) Enable pic programmer (set pic1400 on programmer status -> device)
        2) Read device (checked the calibration data box)
        3) Window -> Calibration data..

The calibration data displayed was:

        Kref:  Invalid Data
        Kbg:   Invalid Data
        Kthrm: Invalid Data
        Ktc:   Invalid Data
        Kin:   255
        Kwdt:  255

Note: the device is new, never UV erase.
Where is the problem? I can't delete (and program) the devide before read
this data, they are too important for the 16 bit A/D.
Thank's.

===================================================
Alboni Giorgio
Faenza (Ra) ITALY
E-Mail: rac1337@racine.ravenna.it
http://www.geocities.com/SiliconValley/Heights/5444
===================================================