Stephen H Alsop wrote:
>
> I have just downloaded the new version of MPLAB 3.22 and did a full install
> on win95 (and stupidly removed my previous version).
>
> I have set it for the correct processor and MPLAB/SIM mode.
>
> Whenever I try to open my test project I get an initial error message
> saying 'Error opening hex file' which then disappears - this may not be
> relevant.
>
> However, when I try to build or compile my test project I get a message box
> saying
>
> Status:
>   file not found
>
> Command Line:
>   c:\projects\test.asm
>
> Yet the 'test.asm' file is in the correct folder and did build ok with the
> previous version of MPLAB and will assemble if MPASMWIN is run directly.
>
> I have reinstalled MPLAB but still get the same result.  It must be a
> simple setup error yet I cannot locate it.  It could be that MPASM is not
> getting called from within MPLAB (MPASM has installed into the MPLAB
> folder).
>
> If anyone else has had a similar problem and knows what to do then please
> let me know.
>
> Many thanks
>
> email: s.ssystems@easynet.co.uk
> www  : http://easyweb.easynet.co.uk/~s.ssystems
> Stephen H Alsop, JP, S&S Systems Ltd, Bretton Court
> Manor Road, Wales Village, Sheffield, S31 8PD, England.
> Tel: 01909 773399 * Fax: 01909 773645 * Mobile: 0973 305527


I just installed ver 3.22 works fine in my system.
try to run scandisk

Andre
--



















                     _____________________________________
                    /                                    /\
                   /   Andre  Abelian  818.840-0003     /
/\                                                 /       Data Image
Technology       _/ /                                             /
andreabelian@earthlink.net    / \/
                /        1128 Alameda Ave.ste 4      /\
               /           Glendale  CA  91201      /
/
              /____________________________________/ /
              \____________________________________\/
               \  \  \  \  \  \   \  \  \  \  \  \  \