Next try ... -- _______________________________________________________ | _____________ | | Dipl.-Ing. Stefan M. Ranguelov /____________/| | | ||||||||||||| | | tel.: +49 (30) 20 181 251 | | priv.: +49 (30) 513 66 23 | | s-mail: D-10319 Berlin, Mellenseestr. 39/10 | | ---------------------------------------------------- | | e-mail: ranguelo@informatik.hu-berlin.de | /) WWW: http://www.informatik.hu-berlin.de/~ranguelo (\ / ) PGP key: on request or from WWW-page ( \ _( (|_______________________________________________________|) ) /> (((\ \) /,) / ) / //))/ (\\\\ \_/ / \ \_/ ///// \ / \ / \ _/ Subject: Message not deliverable Date: Tue, 25 Mar 1997 03:44:24 -0700 From: Hub.Admin@ccmail.microchip.com (Administrator) To: Stefan Ranguelov Antonio Almeida wrote: > > Are there any SPI RAMs width some Kbytes ? If not, is any > "friendly" way to use normal RAMs width the PIC (i mean, using not to much > pins) ? > I red an article about DALLAS DS 1380/1381. It have 2k x 8bit. It have two 8 bit Ports and 2 control lines. Over the first port the PIC can supply Adress/Data. In a 'transparent' mode the 8 lines of the PIC can be switched through to the second port an can be used as normal port pins. So you effective need two pins on the PIC for the control signals. I don't have any price information on this chip. St. -- __________________________________________________________ | _____________ | | Dipl.-Ing. Stefan M. Ranguelov /____________/| | | ||||||||||||| | | tel.: +49 (30) 20 181 251 | | priv.: +49 (30) 513 66 23 | | s-mail: D-10319 Berlin, Mellenseestr. 39/10 | | ------------------------------------------------------ | | e-mail: ranguelo@informatik.hu-berlin.de | /) WWW: http://www.informatik.hu-berlin.de/~ranguelo (\ / ) PGP key: on request or from WWW-page ( \ _( (|__________________________________________________________|) ) /> (((\ \) /,) / ) / //))/ (\\\\ \_/ / \ \_/ ///// \ / \ / \ _/ \_ /